1.INSPECT SEAT MEMORY SWITCH
Check the resistance.
| *a | Component without harness connected
(Seat Memory Switch) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 3 (M1) - 1 (E) | Memory 1 switch on | Below 1 Ω |
| 4 (M2) - 1 (E) | Memory 2 switch on | Below 1 Ω |
| 2 (MRY) - 1 (E) | SET switch on | Below 1 Ω |
If the result is not as specified, replace the seat memory switch.