1.INSPECT FRONT NO. 2 SPEAKER ASSEMBLY
w/o Woofer:
When there is a malfunction such as noise from a speaker or no sound at all, replace the speaker with a new one and check that the malfunction disappears.
Malfunction disappears.
Connect the connectors to the front No. 2 speakers.
When there is a possibility that either the right or left front No. 2 speaker is defective, inspect by interchanging the right one with the left one.
Perform the inspection above on both the LH and RH side.
for LH, w/ Woofer:
| *a | Component without harness connected
(Front No. 2 Speaker Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3 (TWL-) - 4 (TWL+) | Always | 3.4 to 5.2 Ω |
If the result is not as specified, replace the front No. 2 speaker assembly.
for RH, w/ Woofer:
| *a | Component without harness connected
(Front No. 2 Speaker Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3 (TWR-) - 4 (TWR+) | Always | 3.4 to 5.2 Ω |
If the result is not as specified, replace the front No. 2 speaker assembly.