Home › Vehicle Exterior › HORN › HORN
RM30B0U _59 Vehicle Exterior _009440 HORN _0051125 HORN G

HORN  HORN  INSPECTION  


PROCEDURE

Hide 1.INSPECT LOW PITCHED HORN ASSEMBLY

B114453
2.75,0.333 2.229,0.208 true 1.969,1.365 2.167,1.865 false 2.854,0.26 3.021,0.438 0.167,0.177 10 *1 0.115,0.073 0.292,0.26 0.177,0.188 10 *a 2.26,1.875 2.354,2.052 0.094,0.177 10 1
*1 Horn Body
*a Component without harness connected
(Low Pitched Horn Assembly)


a.

Apply battery voltage and check operation of the low pitched horn according to the table below.

OK:
Measurement Condition Specified Condition
Battery positive (+) → Terminal 1
Battery negative (-) → Hone body
Low pitched horn sounds


If the result is not as specified, replace the low pitched horn assembly.


Hide 2.INSPECT HIGH PITCHED HORN ASSEMBLY

B114453
2.75,0.333 2.229,0.208 true 1.969,1.365 2.167,1.865 false 2.854,0.26 3.021,0.438 0.167,0.177 10 *1 0.115,0.073 0.292,0.26 0.177,0.188 10 *a 2.26,1.875 2.354,2.052 0.094,0.177 10 1
*1 Horn Body
*a Component without harness connected
(High Pitched Horn Assembly)


a.

Apply battery voltage and check operation of the high pitched horn according to the table below.

OK:
Measurement Condition Specified Condition
Battery positive (+) → Terminal 1
Battery negative (-) → Hone body
High pitched horn sounds


If the result is not as specified, replace the high pitched horn assembly.