Home › Vehicle Exterior › HORN › RELAY
RM30B0U _59 Vehicle Exterior _009440 HORN _0051126 RELAY G

HORN  RELAY  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT HORN RELAY ASSEMBLY

a.
E226254
2.896,0.802 3.177,0.802 false 3.177,1.125 2.781,1.125 false 2.021,0.813 2.313,0.813 false 3.177,1.573 2.781,1.573 false 1.906,0.729 2.021,0.927 0.115,0.198 10 1 3.208,0.719 3.323,0.917 0.115,0.198 10 2 3.208,1.042 3.323,1.24 0.115,0.198 10 5 3.208,1.49 3.323,1.688 0.115,0.198 10 3

Remove the horn relay assembly.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 - 5 Voltage is not applied between terminals 1 and 2 10 kΩ or higher
3 - 5 Voltage is applied between terminals 1 and 2 Below 1 Ω


If the result is not as specified, replace the horn relay assembly.