Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT BUMPER
RM30B0U _59 Vehicle Exterior _009441 EXTERIOR PANELS / TRIM _0051127 FRONT BUMPER A

EXTERIOR PANELS / TRIM  FRONT BUMPER  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:

A bolt without a torque specification is shown in the standard bolt chart.

Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS


PROCEDURE

Hide 1.INSTALL FRONT BUMPER UPPER REINFORCEMENT SUB-ASSEMBLY

a.

Install the front bumper upper reinforcement sub-assembly with the 2 bolts.


Hide 2.INSTALL FRONT BUMPER SIDE RETAINER LH

a.

Attach the claw to install the front bumper side retainer LH.


b.

Install the screw.


c.

Install the clip.


Hide 3.INSTALL FRONT BUMPER SIDE RETAINER RH

HINT:

Use the same procedure described for the LH side.


Hide 4.INSTALL HEADLIGHT ASSEMBLY LH

Hide 5.INSTALL HEADLIGHT ASSEMBLY RH

HINT:

Use the same procedure described for the LH side.


Hide 6.INSTALL FRONT BUMPER REINFORCEMENT

a.

Install the front bumper reinforcement with the 8 bolts.

Torque:
50 N*m (510 kgf*cm, 37 ft.*lbf)


b.

Attach the 3 clamps.


Hide 7.INSTALL FRONT BUMPER CENTER STAY SUB-ASSEMBLY

a.

Install the front bumper center stay sub-assembly with the 2 bolts.


b.

Install the clip.


Hide 8.INSTALL FRONT BUMPER NO. 2 ENERGY ABSORBER

a.

Install the front bumper No. 2 energy absorber.


Hide 9.INSTALL FRONT BUMPER COVER

a.

w/ Fog Light:

Connect the 2 fog light connectors.


b.

Attach the 8 claws to install the front bumper cover.


c.

Install the 2 bolts and clip.


d.

Install the center hood cushion and 2 radiator grille protectors.


e.
B340222
0.135,0.229 0.448,0.385 0.313,0.156 10 *a 0.146,0.813 0.458,0.969 0.313,0.156 10 *b
*a Correct
*b Incorrect


Install the pin hold clip and screw.

HINT:
·

Insert the pin hold clip with the slot aligned vertically. Do not rotate the clip after inserting it. After installation, confirm that the slot is vertical.

·

Use the same procedure for both pin hold clips and screws.




f.

Install the 6 screws.


Hide 10.INSTALL FRONT FENDER FRONT SPLASH SHIELD LH

a.

Attach the clamp to install the front fender front splash shield LH.


b.

Install the 3 screws.


Hide 11.INSTALL FRONT FENDER FRONT SPLASH SHIELD RH

HINT:

Use the same procedure described for the LH side.


Hide 13.ADJUST FOG LIGHT AIMING (w/ Fog Light)