1.REMOVE FRONT FENDER FRONT SPLASH SHIELD LH
Remove the 3 screws.
Detach the clamp and remove the front fender front splash shield LH.
2.REMOVE FRONT FENDER FRONT SPLASH SHIELD RH
Use the same procedure described for the LH side.
3.REMOVE FRONT BUMPER COVER
Remove the 6 screws.
Using a screwdriver, turn the pin hold clip 90° and remove the pin hold clip and screw.
Use the same procedure for both pin hold clips and screws.
| *1 | Center Hood Cushion |
| *2 | Radiator Grille Protector |
Remove the center hood cushion and 2 radiator grille protectors.
Remove the 2 bolts and clip.
| *1 | Protective Tape |
Put protective tape around the front bumper cover.
| *1 | Protective Tape |
Detach the 8 claws and remove the front bumper cover.
w/ Fog Light:
Disconnect the 2 fog light connectors.
4.REMOVE FRONT BUMPER NO. 2 ENERGY ABSORBER
Remove the front bumper No. 2 energy absorber.
5.REMOVE FRONT BUMPER CENTER STAY SUB-ASSEMBLY
Remove the clip.
Remove the 2 bolts and front bumper center stay sub-assembly.
6.REMOVE FRONT BUMPER REINFORCEMENT
Detach the 3 clamps.
Remove the 8 bolts and front bumper reinforcement.
7.REMOVE HEADLIGHT ASSEMBLY LH
8.REMOVE HEADLIGHT ASSEMBLY RH
Use the same procedure described for the LH side.
9.REMOVE FRONT BUMPER SIDE RETAINER LH
Using a screwdriver, turn the clip 90° and remove the clip.
Remove the screw.
Detach the claw and remove the front bumper side retainer LH.
10.REMOVE FRONT BUMPER SIDE RETAINER RH
Use the same procedure described for the LH side.
11.REMOVE FRONT BUMPER UPPER REINFORCEMENT SUB-ASSEMBLY
Remove the 2 bolts and front bumper upper reinforcement sub-assembly.