Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT DOOR OUTSIDE MOULDING
RM30B0U _59 Vehicle Exterior _009441 EXTERIOR PANELS / TRIM _0051136 FRONT DOOR OUTSIDE MOULDING A

EXTERIOR PANELS / TRIM  FRONT DOOR OUTSIDE MOULDING  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The procedures listed below are for the LH side.



PROCEDURE

Hide 1.INSTALL FRONT DOOR LOWER OUTSIDE MOULDING SUB-ASSEMBLY LH

HINT:

When installing the front door lower outside moulding, heat the front door panel and front door lower outside moulding using a heat light.


Standard:
Item Temperature
Front Door Panel 40 to 60°C (104 to 140°F)
Front Door Lower Outside Moulding 20 to 30°C (68 to 86°F)


NOTICE:

Do not heat the front door panel and front door lower outside moulding excessively.


a.

Clean the front door panel surface.

i.

Using a heat light, heat the front door panel surface.


ii.

Remove the double-sided tape from the front door panel surface.


iii.

Wipe off any tape adhesive residue with cleaner.



b.
B340207
0.5,0.188 0.75,0.188 0.75,0.188 0.75,0.635 true 2.406,1.167 2.406,1.542 2.406,1.542 2.531,1.542 true 0.344,0.104 0.531,0.292 0.188,0.188 10 *1 2.552,1.469 2.729,1.646 0.177,0.177 10 *2
*1 Protective Tape
*2 Double-sided Tape


Install the front door lower outside moulding sub-assembly LH.

i.

Using a heat light, heat the front door lower outside moulding sub-assembly LH and the front door panel surface.


ii.

Remove the peeling paper from the face of the front door outside moulding upper pad.

HINT:

After removing the peeling paper, keep the exposed adhesive free from foreign matter.



iii.

Attach the 10 clips and double-sided tape to install the front door lower outside moulding sub-assembly LH.

HINT:

Press the front door lower outside moulding sub-assembly LH firmly to install it.