Home › Drivetrain › AXLE AND DIFFERENTIAL › STEERING KNUCKLE
RM30B0U _52 Drivetrain _009469 AXLE AND DIFFERENTIAL _0051192 STEERING KNUCKLE A

AXLE AND DIFFERENTIAL  STEERING KNUCKLE  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.INSTALL STEERING KNUCKLE LH

a.

Secure the steering knuckle in a vise.

NOTICE:

When using a vise, do not overtighten it.



b.

Install the front brake dust cover to the steering knuckle.


c.

Install the front axle hub sub-assembly with the 4 bolts.

Torque:
96 N*m (979 kgf*cm, 71 ft.*lbf)

NOTICE:

Do not place the hub and bearing's magnet rotor side so that it is facing downward, and do not allow the magnet rotor side to become damaged or contact foreign matter.



Hide 2.INSTALL FRONT LOWER BALL JOINT ASSEMBLY LH

Hide 3.INSTALL FRONT AXLE HUB SUB-ASSEMBLY LH