Home › Suspension › FRONT SUSPENSION › FRONT LOWER BALL JOINT
RM30B0U _53 Suspension _009473 FRONT SUSPENSION _0051205 FRONT LOWER BALL JOINT G

FRONT SUSPENSION  FRONT LOWER BALL JOINT  INSPECTION  


PROCEDURE

Hide 1.INSPECT FRONT LOWER BALL JOINT ASSEMBLY LH

a.
ZX01712

Inspect the turning torque of the ball joint.

i.

Secure the front lower ball joint in a vise using aluminum plates.


ii.

Install the nut to the front lower ball joint stud.


iii.

Move the stud back and forth several times. Using a torque wrench, turn the nut continuously at a rate of 3 to 5 seconds per turn and take the torque reading on the 5th turn.

Standard turning torque:

0.98 to 3.43 N*m (10 to 35 kgf*cm, 8.7 to 30 in.*lbf)


If the turning torque is not within the specified range, replace the front lower ball joint with a new one.



b.

Inspect the dust cover.

i.

Check that the dust cover is not cracked and that there is no grease on it.