Home › Suspension › FRONT SUSPENSION › FRONT STABILIZER BAR
RM30B0U _53 Suspension _009473 FRONT SUSPENSION _0051206 FRONT STABILIZER BAR G

FRONT SUSPENSION  FRONT STABILIZER BAR  INSPECTION  


PROCEDURE

Hide 1.INSPECT FRONT STABILIZER LINK ASSEMBLY LH

a.
C066721

Inspect the turning torque of the ball joint.

i.

Secure the front stabilizer link assembly in a vise using aluminum plates.


ii.

Install the nut to the front stabilizer link assembly stud.


iii.

Move the stud back and forth several times. Using a torque wrench, turn the nut continuously at a rate of 3 to 5 seconds per turn and take the torque reading on the 5th turn.

Standard turning torque:

0.05 to 1.96 N*m (0.5 to 20 kgf*cm, 0.4 to 17 in.*lbf)


If the turning torque is not within the specified range, replace the front stabilizer link assembly with a new one.



b.

Inspect the dust cover.

i.

Check that the dust cover is not cracked and that there is no grease on it.