Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.REMOVE REAR WHEEL
2.DISCONNECT SKID CONTROL SENSOR WIRE LH
Remove the 2 nuts and disconnect the skid control sensor wire from the rear upper control arm.
3.REMOVE REAR UPPER CONTROL ARM ASSEMBLY LH
Using a jack and wooden block, raise the vehicle and hold the rear No. 2 suspension arm assembly LH together with the rear axle carrier at the standard vehicle height.
Remove the 2 bolts, 2 nuts and upper control arm.
Since a stopper nut is used, remove the bolt.