Home › Suspension › REAR SUSPENSION › REAR STABILIZER BAR
RM30B0U _53 Suspension _009475 REAR SUSPENSION _0051213 REAR STABILIZER BAR A

REAR SUSPENSION  REAR STABILIZER BAR  REMOVAL  


PROCEDURE

Hide 1.REMOVE REAR WHEEL

Hide 2.REMOVE REAR STABILIZER LINK ASSEMBLY LH

a.
C129662

Remove the 2 nuts and 2 cushions and disconnect the link from the No. 2 suspension arm.

HINT:

If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud.



Hide 3.REMOVE REAR STABILIZER LINK ASSEMBLY RH

HINT:

Use the same procedure described for the LH side.


Hide 4.REMOVE REAR SUSPENSION MEMBER BRACE LH

C129663

a.

Remove the 2 bolts and member brace from the suspension member.


Hide 5.LOOSEN REAR NO. 2 SUSPENSION ARM ASSEMBLY LH

C266840

a.

Loosen the 2 bolts of the suspension arm.

NOTICE:
·

Do not remove the bolts and nuts, only loosen them.

·

Since a stopper nut is used, loosen the bolt.




Hide 6.REMOVE REAR COIL SPRING LH

a.
C129671

Support the No. 2 suspension arm LH with a jack.

NOTICE:

Place a wooden or rubber block between the jack and arm.



b.
C129668

Remove the bolt located on the rear axle carrier of the rear No. 2 suspension arm.


c.

Lower the jack gradually to remove the rear coil spring together with the rear upper coil spring insulator.


Hide 7.REMOVE REAR UPPER COIL SPRING INSULATOR LH

a.

Remove the rear upper coil spring insulator from the rear coil spring.


Hide 8.REMOVE REAR LOWER COIL SPRING INSULATOR LH

a.

Remove the rear lower coil spring insulator from the rear No. 2 suspension arm.


Hide 9.REMOVE REAR STABILIZER BAR

C129664

a.

Remove the 4 bolts and 2 stabilizer brackets from the suspension member.


b.

Remove the stabilizer bar from the suspension member.


Hide 10.REMOVE REAR STABILIZER BUSHING

a.

Remove the 2 rear stabilizer bushes from the rear stabilizer bar.