1.REMOVE BOX BOTTOM MAT
Remove the box bottom mat.
2.REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH
|
Protective Tape |
Apply protective tape as shown in the illustration.
Using moulding remover B, detach the 2 clips and remove the instrument cluster finish panel garnish.
3.REMOVE NO. 1 HEATER TO REGISTER DUCT SUB-ASSEMBLY
Remove the 3 screws <A> and No. 1 heater to register duct sub-assembly.
4.REMOVE NO. 2 HEATER TO REGISTER DUCT SUB-ASSEMBLY
Remove the 2 screws <A> and No. 2 heater to register duct sub-assembly.
5.REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY
Use the same procedure to remove the No. 2 instrument panel register assembly on the other side.
Detach the 3 claws and remove the No. 2 instrument panel register assembly.
6.REMOVE NO. 2 INSTRUMENT PANEL WIRE
Detach the 8 wire harness clamps and remove the No. 2 instrument panel wire.
7.REMOVE NAVIGATION ANTENNA ASSEMBLY (w/ Navigation System)
8.REMOVE CENTER INSTRUMENT PANEL REGISTER CONNECTOR
Remove the 2 screws <A> and center instrument panel register connector.
9.REMOVE NO. 2 INSTRUMENT PANEL WIRE
10.REMOVE INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY
11.REMOVE NO. 1 INSTRUMENT PANEL CUSHION
Remove the 2 No. 1 instrument panel cushions.
12.REMOVE NO. 4 INSTRUMENT PANEL CUSHION
Remove the No. 4 instrument panel cushion.