1.REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY
Twist the shift lever knob sub-assembly in the direction indicated by the arrow and remove it.
2.REMOVE PARKING BRAKE HOLE COVER SUB-ASSEMBLY
|
Protective Tape |
Apply protective tape as shown in the illustration.
Using moulding remover B, detach the 9 clips and claw and remove the parking brake hole cover sub-assembly.
3.REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY
Apply protective tape as shown in the illustration.
Using moulding remover B, detach the 12 clips and remove the upper console panel sub-assembly.
|
Protective Tape | - | - |
Disconnect the connector.
4.REMOVE INNER NO. 1 INSTRUMENT PANEL BRACKET COVER LH
Detach the 2 clips and guide and remove the inner No. 1 instrument panel bracket cover LH.
5.REMOVE INNER NO. 1 INSTRUMENT PANEL BRACKET COVER RH
Detach the 2 clips and guide and remove the inner No. 1 instrument panel bracket cover RH.
6.REMOVE UPPER REAR CONSOLE PANEL SUB-ASSEMBLY
Detach the 4 claws and remove the upper rear console panel sub-assembly.
7.REMOVE CONSOLE BOX CARPET
Remove the console box carpet.
8.REMOVE LOWER CENTER INSTRUMENT PANEL FINISH PANEL
|
Protective Tape. |
Apply protective tape as shown in the illustration.
Using moulding remover B, detach the 5 clips and remove the lower center instrument panel finish panel.
9.REMOVE REAR CONSOLE BOX SUB-ASSEMBLY
Remove the 2 screws.
Remove the 4 bolts and rear console box sub-assembly.