1.REMOVE CONSOLE REAR END PANEL SUB-ASSEMBLY
Detach the 4 claws and 2 clips and remove the console rear end panel sub-assembly.
2.REMOVE CONSOLE COMPARTMENT DOOR SUB-ASSEMBLY (except Slide Console Type)
| *1 | Plastic-faced Hammer |
| *2 | Shaft |
Using a plastic-faced hammer, tap the shaft in lightly and then pull it out from the rear console box sub-assembly.
Remove the 2 bushes and console compartment door sub-assembly.
3.REMOVE CONSOLE COMPARTMENT DOOR SUB-ASSEMBLY (for Slide Console Type)
Remove the 4 screws and console compartment door sub-assembly.
4.REMOVE CONSOLE COMPARTMENT DOOR LOCK SUB-ASSEMBLY
Remove the 2 screws and console compartment door lock sub-assembly from the console compartment door sub-assembly.