1. PRECAUTION
Be sure to read Precaution thoroughly before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
If the side airbag has deployed, replace the front seat airbag assembly LH, separate type front seatback spring assembly LH, separate type front seatback pad and separate type front seatback cover with the necessary parts in accordance with the extent of the collision damage.
2.REMOVE FRONT SEAT HEADREST ASSEMBLY
Remove the front seat headrest assembly.
3.REMOVE FRONT OUTER SEAT TRACK BRACKET COVER LH
Operate the front power seat switch (slide switch) to move the seat to the rearmost position.
|
First |
|
Second |
Detach the 2 claws to remove the front outer seat track bracket cover LH as indicated by the arrows in the order shown in the illustration.
4.REMOVE FRONT INNER SEAT TRACK BRACKET COVER LH
|
First |
|
Second |
Detach the 2 claws to remove the front inner seat track bracket cover LH as indicated by the arrows in the order shown in the illustration.
5.REMOVE REAR OUTER SEAT TRACK BRACKET COVER LH
Operate the front power seat switch (slide switch) to move the seat to the foremost position.
|
First |
|
Second |
Detach the 2 claws to remove the rear outer seat track bracket cover LH as indicated by the arrows in the order shown in the illustration.
6.REMOVE REAR INNER SEAT TRACK BRACKET COVER LH
|
First |
|
Second |
Detach the 2 claws to remove the rear inner seat track bracket cover LH as indicated by the arrows in the order shown in the illustration.
7.REMOVE FRONT SEAT ASSEMBLY LH
Remove the 2 bolts.
Operate the front power seat switch (slide switch) to move the seat to the rearmost position.
Remove the 2 bolts.
Operate the front power seat switch (slide switch) to align the front side of the inner adjuster with the front side of the outer adjuster.
Disconnect the cable from negative (-) battery terminal.
Wait at least 90 seconds after disconnecting the cable from the battery negative (-) terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
Detach the 2 clamps and disconnect the connector of the front seat inner belt assembly LH.
Disconnect the connector of the seat heater.
Disconnect the connector of the front seat airbag assembly LH.
Place a finger on the slider, slide the slider to release the lock, and then disconnect the front seat airbag connector.
| *1 | Slider | - | - |
Remove the front seat assembly LH from the vehicle.
Be careful not to damage the vehicle body.