1.INSPECT POWER SEAT MOTOR
Check the operation of the lumbar support motor LH.
| *a | Component without wire harness connected
(Lumbar Support Motor LH) |
Apply battery voltage to the lumbar support motor LH connector, and check that the lumbar support motor LH operates smoothly as follows.
| Condition | Specified Condition |
|---|---|
| Battery positive (+) → Terminal 2
Battery negative (-) → Terminal 1 |
Forward |
| Battery positive (+) → Terminal 1
Battery negative (-) → Terminal 2 |
Backward |
If the result is not as specified, replace the separate type front seatback spring assembly LH.
Check the operation of the slide motor LH.
| *a | Component without wire harness connected
(Slide Motor LH) |
Apply battery voltage to the slide motor LH connector, and check that the slide motor LH operates smoothly as follows.
| Condition | Specified Condition |
|---|---|
| Battery positive (+) → 4 (SLD+)
Battery negative (-) → 1 (SLD-) |
Forward |
| Battery positive (+) → 1 (SLD-)
Battery negative (-) → 4 (SLD+) |
Backward |
If the result is not as specified, replace the separate type front seat cushion spring assembly LH.
Check the operation of the front vertical motor LH.
| *a | Component without wire harness connected
(Front Vertical Motor LH) |
Apply battery voltage to the front vertical motor LH connector, and check that the front vertical motor LH operates smoothly as follows.
| Condition | Specified Condition |
|---|---|
| Battery positive (+) → 4 (FRV+)
Battery negative (-) → 1 (FRV-) |
Upward |
| Battery positive (+) → 1 (FRV-)
Battery negative (-) → 4 (FRV+) |
Downward |
If the result is not as specified, replace the separate type front seat cushion spring assembly LH.
Check the operation of the reclining motor LH.
| *a | Component without wire harness connected
(Reclining Motor LH) |
Apply battery voltage to the reclining motor LH connector, and check that the reclining motor LH operates smoothly as follows.
| Condition | Specified Condition |
|---|---|
| Battery positive (+) → 4 (RCL+)
Battery negative (-) → 1 (RCL-) |
Forward |
| Battery positive (+) → 1 (RCL-)
Battery negative (-) → 4 (RCL+) |
Backward |
If the result is not as specified, replace the separate type front seat cushion spring assembly LH.
Check the operation of the lifter motor LH.
| *a | Component without wire harness connected
(Lifter Motor LH) |
Apply battery voltage to the lifter motor LH connector, and check that the lifter motor LH operates smoothly as follows.
| Condition | Specified Condition |
|---|---|
| Battery positive (+) → 4 (LFT+)
Battery negative (-) → 1 (LFT-) |
Upward |
| Battery positive (+) → 1 (LFT-)
Battery negative (-) → 4 (LFT+) |
Downward |
If the result is not as specified, replace the separate type front seat cushion spring assembly LH.