Home › Vehicle Interior › SEAT › LUMBAR SWITCH
RM30B0U _58 Vehicle Interior _009409 SEAT _0051060 LUMBAR SWITCH G

SEAT  LUMBAR SWITCH  INSPECTION  


PROCEDURE

Hide 1.INSPECT POWER SEAT SWITCH ASSEMBLY

B239575
2.573,1.115 2.083,1.115 false 1.438,1.125 0.979,1.125 false 2.094,3.823 1.948,3.385 false 2.073,3.385 2.417,3.823 false 1.229,3.813 1.583,3.385 false 1.646,3.833 1.813,3.385 false 1.156,3.813 1.313,4.01 0.156,0.198 10 B 1.594,3.823 1.75,4.021 0.156,0.198 10 H 2.063,3.823 2.219,4.021 0.156,0.198 10 E 2.417,3.823 2.573,4.021 0.156,0.198 10 R 0.823,1.042 1.135,1.198 0.313,0.156 10 *1 2.615,1.031 2.927,1.188 0.313,0.156 10 *2 0.677,2.583 0.99,2.74 0.313,0.156 10 *a
*1 Hold Switch
*2 Release Switch
*a Component without harness connected
(Power Seat Switch Assembly)


a.

Check the resistance.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
5 (B) - 3 (H) Hold switch on Below 1 Ω
2 (E) - 1 (R)
2 (E) - 3 (H) Neutral Below 1 Ω
2 (E) - 1 (R)
2 (E) - 3 (H) Release switch on Below 1 Ω
5 (B) - 1 (R)


If the result is not as specified, replace the power seat switch assembly.