Home › Vehicle Interior › SEAT › FRONT SEAT CUSHION HEATER(for Driver Side)
RM30B0U _58 Vehicle Interior _009409 SEAT _0051062 FRONT SEAT CUSHION HEATER(for Driver Side) G

SEAT  FRONT SEAT CUSHION HEATER(for Driver Side)  INSPECTION  


PROCEDURE

Hide 1.INSPECT FRONT SEAT CUSHION HEATER ASSEMBLY LH

B341145
1.583,1.583 1.167,1.583 true 2.083,1.583 2.583,1.583 true 0.438,2.177 0.75,2.333 0.313,0.156 10 *1 1.927,2.146 2.24,2.302 0.313,0.156 10 *2 0.333,1.375 0.646,1.531 0.313,0.156 10 *a 1.01,1.51 1.323,1.667 0.313,0.156 10 *3 2.604,1.5 2.917,1.656 0.313,0.156 10 *3
*1 Connector A
*2 Connector B
*3 Thermostat
*a Component without harness connected
(Front Seat Cushion Heater Assembly LH)


a.

Check the front seat cushion heater assembly LH.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
A-2 - B-3 Seat cushion heater temperature 20°C (68°F) 3.25 to 3.31 Ω
A-3 - B-2 1.78 to 1.82 Ω
A-1 - B-1 Below 1 Ω


If the result is not as specified, replace the front seat cushion heater assembly LH.


ii.

Check the thermostat resistance.

Standard Resistance:
Tester Connection Condition Specified Condition
A-2 - B-3 Thermostat temperature 42°C (108°F) 10 kΩ or higher
A-3 - B-2 10 kΩ or higher


If the result is not as specified, replace the front seat cushion heater assembly LH.