Home › Drivetrain › DRIVE SHAFT / PROPELLER SHAFT › FRONT DRIVE SHAFT ASSEMBLY(for AWD)
RM30B0U _52 Drivetrain _009984 DRIVE SHAFT / PROPELLER SHAFT _0054769 FRONT DRIVE SHAFT ASSEMBLY(for AWD) G

DRIVE SHAFT / PROPELLER SHAFT  FRONT DRIVE SHAFT ASSEMBLY(for AWD)  INSPECTION  


CAUTION / NOTICE / HINT

NOTICE:
·

When using a vise, place aluminum plates between the part and vise.

·

When using a vise, do not overtighten it.



PROCEDURE

Hide 1.INSPECT FRONT DRIVE SHAFT ASSEMBLY

a.
C116430

Check that there is no excessive play in the radial direction of the outboard joint.


b.

Check that the inboard joint slides smoothly in the thrust direction.


c.

Check that there is no severe play in the radial direction of the inboard joint.


d.

Check the 2 joint boots for damage.


e.
C278922
0.094,0.083 0.406,0.281 0.313,0.198 10 *A 0.094,1.854 0.406,2.052 0.313,0.198 10 *B 1.531,1.573 1.844,1.771 0.313,0.198 10 (A) 1.594,3.104 1.906,3.302 0.313,0.198 10 (A)
*A for LH Side
*B for RH Side


Check that the 2 joint boots are not stretched or contracted when the front drive shaft is at the standard length.

Length (A):
Item Length
for TMMC Made LH Side 571.9 mm (1.88 ft.)
RH Side 918.0 mm (3.01 ft.)
except TMMC Made LH Side 577.6 mm (1.89 ft.)
RH Side 922.4 mm (3.03 ft.)


NOTICE:

Keep the drive shaft assembly level during inspection.


If the boots are stretched or contracted, correct them.