Home › Drivetrain › DRIVE SHAFT / PROPELLER SHAFT › PROPELLER SHAFT ASSEMBLY
RM30B0U _52 Drivetrain _009984 DRIVE SHAFT / PROPELLER SHAFT _0054772 PROPELLER SHAFT ASSEMBLY G

DRIVE SHAFT / PROPELLER SHAFT  PROPELLER SHAFT ASSEMBLY  INSPECTION  


PROCEDURE

Hide 1.INSPECT PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY

a.
C127522

Using a dial indicator, measure the propeller shaft runout for the front side.

Maximum runout:

0.4 mm (0.0157 in.)


If the shaft runout is more than the maximum, replace the propeller shaft.

NOTICE:

Place the dial indicator on the center of the shaft, and perpendicular to the shaft.



b.
C127523

Using a dial indicator, measure the propeller shaft runout for the rear side.

Maximum runout:

0.4 mm (0.0157 in.)


If the shaft runout is more than the maximum, replace the propeller shaft.

NOTICE:

Place the dial indicator on the center of the shaft, and perpendicular to the shaft.