1.INSPECT POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY (for Driver Side)
| *a | Unlock |
| *b | Lock |
| *c | Component without harness connected
(Power Window Regulator Master Switch Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 2 (L) - 1 (E) | Lock | Below 1 Ω |
| 2 (L) - 1 (E) | Off | 10 kΩ or higher |
| 9 (UL) - 1 (E) | Unlock | Below 1 Ω |
| 9 (UL) - 1 (E) | Off | 10 kΩ or higher |
If the result is not as specified, replace the power window regulator master switch assembly.
2.INSPECT DOOR CONTROL SWITCH (for Front Passenger Side)
| *a | Unlock |
| *b | Lock |
| *c | Component without harness connected
(Door Control Switch) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 4 (L) - 3 (E) | Lock | Below 1 Ω |
| 4 (L) - 3 (E) | Off | 10 kΩ or higher |
| 2 (UL) - 3 (E) | Unlock | Below 1 Ω |
| 2 (UL) - 3 (E) | Off | 10 kΩ or higher |
If the result is not as specified, replace the door control switch.