Home › Vehicle Interior › DOOR LOCK › FRONT DOOR LOCK
RM30B0U _58 Vehicle Interior _009874 DOOR LOCK _0054786 FRONT DOOR LOCK G

DOOR LOCK  FRONT DOOR LOCK  INSPECTION  


PROCEDURE

Hide 1.INSPECT FRONT DOOR WITH MOTOR LOCK ASSEMBLY LH

a.
B171377
1.385,3.781 1.385,3.031 1.385,3.031 1.198,3.031 true 0.583,3.771 0.583,3.021 0.583,3.021 0.396,3.021 true 2.146,3.552 2.583,3.875 0.438,0.323 10 *c 2.677,3.198 3.115,3.594 0.438,0.396 10 *b 0.24,0.167 0.688,0.448 0.448,0.281 10 *a 0.271,2.948 0.708,3.365 0.438,0.417 10 L 1,2.948 1.385,3.365 0.385,0.417 10 UL
*a Component without harness connected
(Front Door with Motor Lock Assembly LH)
*b Unlock
*c Lock


Check the operation of the front door lock motor.

i.

Apply battery voltage and check the operation of the front door lock motor.

OK:
Measurement Condition Specified Condition
Battery positive (+) → 4 (L)
Battery negative (-) → 1 (UL)
Locks
Battery positive (+) → 1 (UL)
Battery negative (-) → 4 (L)
Unlocks


If the result is not as specified, replace the front door with motor lock assembly LH.



b.
B171377
1.073,4.167 1.073,4.521 1.073,4.521 1.313,4.521 true 0.896,4.167 0.896,4.521 0.896,4.521 0.698,4.521 true 2.167,3.563 2.417,3.802 0.25,0.24 10 *c 2.688,3.198 3.031,3.458 0.344,0.26 10 *b 0.167,0.156 0.708,0.635 0.542,0.479 10 *a 1.375,4.448 1.604,4.625 0.229,0.177 10 E 0.302,4.448 0.844,4.635 0.542,0.188 10 LSSR
*a Component without harness connected
(Front Door with Motor Lock Assembly LH)
*b Unlock
*c Lock


Check the operation of the door unlock detection switch (w/ Smart Entry and Start System or Theft Deterrent System).

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
7 (E) - 8 (LSSR) Locked 10 kΩ or higher
Unlocked Below 1 Ω


If the result is not as specified, replace the front door with motor lock assembly LH.



c.
B273324
2.729,3.531 2.729,3.875 2.729,3.875 2.844,3.875 true 2.417,3.531 2.417,4.094 2.417,4.094 2.667,4.094 true 2.271,3.531 2.271,4.094 2.271,4.094 2.083,4.094 true 2.802,2.031 3.156,2.333 0.354,0.302 10 *b 2.99,0.969 3.292,1.302 0.302,0.333 10 *c 0.26,0.156 0.813,0.542 0.552,0.385 10 *a 2.896,3.802 3.146,4.083 0.25,0.281 10 E 2.729,4.021 3.01,4.333 0.281,0.313 10 L 1.885,4.021 2.323,4.302 0.438,0.281 10 UL
*a Component without harness connected
(Front Door with Motor Lock Assembly LH)
*b Unlock
*c Lock


Check the operation of the door key lock and unlock switch.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
9 (L) - 7 (E) Held to lock side Below 1 Ω
9 (L) - 7 (E) Neutral or held to unlock side 10 kΩ or higher
10 (UL) - 7 (E) Held to unlock side Below 1 Ω
10 (UL) - 7 (E) Neutral or held to lock side 10 kΩ or higher


If the result is not as specified, replace the front door with motor lock assembly LH.



Hide 2.INSPECT FRONT DOOR WITH MOTOR LOCK ASSEMBLY RH

a.
B171378
2.854,3.792 2.854,3.125 2.854,3.125 3.021,3.125 true 2.052,3.792 2.052,3.125 2.052,3.125 2.219,3.125 true 0.208,0.146 0.729,0.542 0.521,0.396 10 *a 1.156,3.635 1.688,4.031 0.531,0.396 10 *c 0.615,3.229 0.948,3.594 0.333,0.365 10 *b 3.083,3.042 3.281,3.177 0.198,0.135 10 UL 2.302,3.042 2.396,3.177 0.094,0.135 10 L
*a Component without harness connected
(Front Door with Motor Lock Assembly RH)
*b Unlock
*c Lock


Check the operation of the front door lock motor.

i.

Apply battery voltage and check the operation of the front door lock motor.

OK:
Measurement Condition Specified Condition
Battery positive (+) → 4 (L)
Battery negative (-) → 1 (UL)
Locks
Battery positive (+) → 1 (UL)
Battery negative (-) → 4 (L)
Unlocks


If the result is not as specified, replace the front door with motor lock assembly RH.



b.
B273325
2.292,3.75 2.292,4.115 2.292,4.115 2.167,4.115 true 2.458,3.75 2.458,4.115 2.458,4.115 2.573,4.115 true 0.229,0.167 0.844,0.594 0.615,0.427 10 *a 1.104,3.177 1.521,3.531 0.417,0.354 10 *c 0.552,2.771 0.958,3.25 0.406,0.479 10 *b 2.021,4.042 2.323,4.333 0.302,0.292 10 E 2.646,4.042 3.177,4.385 0.531,0.344 10 LSSR
*a Component without harness connected
(Front Door with Motor Lock Assembly RH)
*b Unlock
*c Lock


Check the operation of the door unlock detection switch.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
7 (LSSR) - 8 (E) Locked 10 kΩ or higher
7 (LSSR) - 8 (E) Unlocked Below 1 Ω


If the result is not as specified, replace the front door with motor lock assembly RH.