Home › Vehicle Interior › DOOR LOCK › REAR DOOR LOCK
RM30B0U _58 Vehicle Interior _009874 DOOR LOCK _0054787 REAR DOOR LOCK A

DOOR LOCK  REAR DOOR LOCK  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

CAUTION:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 3.REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

Hide 4.REMOVE DOOR ASSIST GRIP COVER LH

Hide 5.REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG LH

Hide 6.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

Hide 7.REMOVE REAR DOOR SERVICE HOLE COVER LH

Hide 8.REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH

Hide 9.REMOVE REAR DOOR QUARTER WINDOW GLASS LH

Hide 10.REMOVE REAR DOOR GLASS SUB-ASSEMBLY LH

Hide 11.REMOVE REAR DOOR GLASS RUN LH

Hide 12.REMOVE REAR DOOR WITH MOTOR LOCK ASSEMBLY LH

a.
B345347

Disconnect the connector.


b.

Using a T30 "TORX" socket wrench, remove the 3 screws.


c.
B337023
1.365,0.51 1.583,0.688 0.219,0.177 10 true *a
*a Downward


Move the rear door with motor lock assembly LH downward and pull the release plate out of the rear door outside handle frame.


d.

Remove the rear door with motor lock assembly LH and cables as a unit.


e.
B337024

Remove the door lock wiring harness seal from the rear door with motor lock assembly LH.


Hide 13.REMOVE REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH

Hide 14.REMOVE REAR DOOR INSIDE LOCKING CABLE ASSEMBLY LH