Home › Vehicle Interior › SEAT BELT › FRONT SEAT INNER BELT ASSEMBLY
RM30B0U _58 Vehicle Interior _009991 SEAT BELT _0054790 FRONT SEAT INNER BELT ASSEMBLY G

SEAT BELT  FRONT SEAT INNER BELT ASSEMBLY  INSPECTION  


PROCEDURE

Hide 1.INSPECT FRONT SEAT INNER BELT ASSEMBLY LH

a.
B341398
1.5,1.573 1.229,1.208 false 0.708,1.604 0.99,1.219 false 1.01,0.406 1.323,0.563 0.313,0.156 10 *1 2.26,0.417 2.573,0.573 0.313,0.156 10 *2 0.094,0.073 0.406,0.229 0.313,0.156 10 *a 1.365,1.615 1.781,1.823 0.417,0.208 10 LSP- 0.49,1.625 0.906,1.833 0.417,0.208 10 LSP+
*1 Connector A
*2 Connector B
*a Component without harness connected
(Front Seat Inner Belt Assembly LH)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
A-3 (LSP-) - B-1 Always Below 1 Ω
A-4 (LSP+) - B-2 Always Below 1 Ω


If the result is not as specified, replace the front seat inner belt assembly LH.


Hide 2.INSPECT FRONT SEAT INNER BELT ASSEMBLY RH

a.
B339091
2.292,0.458 2.594,0.26 2.594,0.26 2.76,0.26 false 1.563,2.969 1.063,3.01 true 2.427,3.01 1.844,2.969 true 2.802,0.198 3.115,0.354 0.313,0.156 10 false *1 0.531,2.417 0.844,2.573 0.313,0.156 10 false *a 0.719,2.938 1.333,3.135 0.615,0.198 10 false LSP- 2.458,2.938 3.073,3.135 0.615,0.198 10 false LSP+
*1 Limit Switch
*a Component without harness connected
(Front Seat Inner Belt Assembly RH)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 - 4 Limit switch pushed Below 1 Ω
3 - 4 Limit switch not pushed 10 kΩ or higher


If the result is not as specified, replace the front seat inner belt assembly RH.