Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM(for Radio and Display Type)
RM30B0U _56 Audio / Visual / Telematics _009403 AUDIO / VIDEO _0054849 AUDIO AND VISUAL SYSTEM(for Radio and Display Type) J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(for Radio and Display Type)  Parking Brake Switch Circuit  


WIRING DIAGRAM

This circuit is from the parking brake switch assembly to the radio and display receiver assembly.

WIRING DIAGRAM

E226166
2.604,1.427 3.052,1.594 0.448,0.167 10 G37 2.604,1.594 4.698,1.823 2.094,0.229 10 Parking Brake Switch Assembly 3.708,0.99 3.979,1.156 0.271,0.167 10 1 4.677,2.031 5.135,2.198 0.458,0.167 10 G144 5.24,0.99 5.51,1.156 0.271,0.167 10 6 4.677,2.188 7.01,2.521 2.333,0.333 10 Radio and Display Receiver Assembly 5.417,1.125 5.865,1.292 0.448,0.167 10 PKB

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - PARKING BRAKE SWITCH ASSEMBLY)
a.

Disconnect the G144 radio and display receiver assembly connector.


b.

Disconnect the G37 parking brake switch assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G144-6 (PKB) - G37-1 Always Below 1 Ω
G144-6 (PKB) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

2.INSPECT PARKING BRAKE SWITCH ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.INSPECT PARKING BRAKE SWITCH ASSEMBLY
a.

Remove the parking brake switch assembly.

Click hereBrake>PARKING BRAKE>PARKING BRAKE SWITCH>REMOVAL


b.

Inspect the parking brake switch assembly.

Click hereBrake>PARKING BRAKE>PARKING BRAKE SWITCH>INSPECTION


Result:
Proceed to
OK
NG



OK

NG

REPLACE PARKING BRAKE SWITCH ASSEMBLY