Home › Engine / Hybrid System › CRUISE CONTROL › LANE DEPARTURE ALERT SYSTEM
RM30B0U _51 Engine / Hybrid System _010069 CRUISE CONTROL _0054851 LANE DEPARTURE ALERT SYSTEM C

CRUISE CONTROL  LANE DEPARTURE ALERT SYSTEM  C1AA8  Front Camera Module Incorrect Axial Gap  C1AA9  Front Camera Module Beam Axis Not Adjusted  


DESCRIPTION

If the lane departure warning camera determines that the lane departure warning camera axis has deviated, DTC C1AA8 is stored. Also, if the camera sensor beam axis adjustment is not performed after installing the lane departure warning camera, DTC C1AA9 is stored.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1AA8 Front Camera Module Incorrect Axial Gap While the ignition switch is ON and the lane departure alert system is operating, the lane departure warning camera detects lane departure warning camera beam axis deviation. Lane departure warning camera
C1AA9 Front Camera Module Beam Axis Not Adjusted While the ignition switch is ON, the lane departure warning camera detects that lane departure warning camera adjustment has not been completed. Lane departure warning camera

CAUTION / NOTICE / HINT

NOTICE:

When the lane departure warning camera is replaced with a new one, adjustment of the lane departure warning camera beam axis must be performed.

Click hereEngine / Hybrid System>CRUISE CONTROL>LANE RECOGNITION CAMERA SENSOR>ADJUSTMENT


PROCEDURE

1.ADJUST LANE DEPARTURE WARNING CAMERA
a.

Perform the lane departure warning camera adjustment.

Click hereEngine / Hybrid System>CRUISE CONTROL>LANE RECOGNITION CAMERA SENSOR>ADJUSTMENT


Result:
Proceed to
NEXT



NEXT

2.CLEAR DTC
2.CLEAR DTC
a.

Connect the Techstream to the DLC3.


b.

Turn the ignition switch to ON.


c.

Enter the following menus: Chassis / Lane Departure Alert / Clear DTCs.


d.

Clear the DTCs.

Chassis > Lane Departure Alert > Clear DTCs
50002 355

Result:
Proceed to
NEXT



NEXT

3.CHECK FOR DTC
3.CHECK FOR DTC
a.

Connect the Techstream to the DLC3.

HINT:

If the detection conditions are not met, the system cannot detect the malfunction.



b.

Turn the ignition switch to ON.


c.

Enter the following menus: Chassis / Lane Departure Alert / Trouble Codes.


d.

Check for DTCs.

Chassis > Lane Departure Alert > Trouble Codes
50001 355

Result:
Proceed to
No DTCs are output
DTC C1AA8 and/or C1AA9 are output



No DTCs are output

END (LANE DEPARTURE WARNING CAMERA ADJUSTMENT IS DEFECTIVE)

DTC C1AA8 and/or C1AA9 are output