Home › Engine / Hybrid System › CRUISE CONTROL › LANE DEPARTURE ALERT SYSTEM
RM30B0U _51 Engine / Hybrid System _010069 CRUISE CONTROL _0054851 LANE DEPARTURE ALERT SYSTEM C

CRUISE CONTROL  LANE DEPARTURE ALERT SYSTEM  U0101  Lost Communication with ECM  U0123  Lost Communication with Yaw Rate Sensor Module  U0129  Lost Communication with Brake System Control Module  U0142  Lost Communication with Body Control Module "B"  U0155  Lost Communication with Instrument Panel Cluster (IPC) Control Module (Combination Meter)  


DESCRIPTION

These DTCs are output when a communication malfunction occurs between the sensors and ECUs.

DTC No. Detection Item DTC Detection Condition Trouble Area
U0101 Lost Communication with ECM While the vehicle is being driven at 1 km/h (1 mph) or more, a communication between the ECM and lane departure warning camera stops for 5 seconds or more. CAN communication system
U0123 Lost Communication with Yaw Rate Sensor Module While the vehicle is being driven at 1 km/h (1 mph) or more, a communication between the airbag sensor assembly and lane departure warning camera stops for 5 seconds or more. CAN communication system
U0129 Lost Communication with Brake System Control Module While the ignition switch ON, a communication between the skid control ECU and lane departure warning camera stops for 5 seconds or more. CAN communication system
U0142 Lost Communication with Body Control Module "B" While the ignition switch ON, a communication between the main body ECU (multiplex network body ECU) and lane departure warning camera stops for 5 seconds or more. CAN communication system
U0155 Lost Communication with Instrument Panel Cluster (IPC) Control Module (Combination Meter) While the ignition switch ON, a communication between the combination meter assembly and lane departure warning camera stops for 50 seconds or more. CAN communication system

PROCEDURE

1.CLEAR DTC
a.

Connect the Techstream to the DLC3.


b.

Turn the ignition switch to ON.


c.

Enter the following menus: Chassis / Lane Departure Alert / Clear DTCs.


d.

Clear the DTCs.

Chassis > Lane Departure Alert > Clear DTCs
50002 355

Result:
Proceed to
NEXT



NEXT

2.CHECK FOR DTC
2.CHECK FOR DTC
a.

Connect the Techstream to the DLC3.


b.

Turn the ignition switch to ON.


c.

Enter the following menus: Chassis / Lane Departure Alert / Trouble Codes.


d.

Check for DTCs.

Chassis > Lane Departure Alert > Trouble Codes
50001 355

Result:
Proceed to
No DTCs are output
CAN DTCs are output



No DTCs are output

CAN DTCs are output