The lane departure warning camera monitors its internal condition. When an internal malfunction is detected, the lane departure warning camera stores DTC U1000 and cancels lane departure alert system control.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U1000 | CAN Communication Failure (Message Registry) | When the ignition switch is turned to ON, a CAN communication malfunction is detected. | Lane departure warning camera |
When the lane departure warning camera is replaced with a new one, adjustment of the lane departure warning camera beam axis must be performed.
Click hereEngine / Hybrid System>CRUISE CONTROL>LANE RECOGNITION CAMERA SENSOR>ADJUSTMENT
The lane departure alert system uses the CAN communication system. Inspect the communication function by following How to Proceed with Troubleshooting. Troubleshoot the lane departure alert system after confirming that the communication systems are functioning properly.
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Enter the following menus: Chassis / Lane Departure Alert / Clear DTCs.
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Enter the following menus: Chassis / Lane Departure Alert / Trouble Codes.
Check for DTCs.
| Proceed to |
|---|
| No DTCs are output |
| DTC U1000 is output |
No DTCs are output
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
DTC U1000 is output