Home › Engine / Hybrid System › CRUISE CONTROL › LANE DEPARTURE ALERT SYSTEM
RM30B0U _51 Engine / Hybrid System _010069 CRUISE CONTROL _0054851 LANE DEPARTURE ALERT SYSTEM J

CRUISE CONTROL  LANE DEPARTURE ALERT SYSTEM  Power Source Circuit  


DESCRIPTION

This circuit provides power to operate the lane departure warning camera.

WIRING DIAGRAM

E269534
5.333,1.854 5.792,2.052 0.458,0.198 10 false Q13 5.365,2.021 6.875,2.448 1.51,0.427 10 false Lane Departure Warning Camera 5.438,1.156 5.75,1.354 0.313,0.198 10 false 11 5.74,1.271 6.198,1.469 0.458,0.198 10 false GND 5.51,0.219 5.667,0.417 0.156,0.198 10 false 7 5.771,0.344 6.229,0.542 0.458,0.198 10 false IGB 2.573,0.552 3.531,0.781 0.958,0.229 10 false ECU-IG NO.2 0.531,0.333 1.927,0.635 1.396,0.302 10 false from IG1 NO.1 Relay

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (LANE DEPARTURE WARNING CAMERA - BATTERY AND BODY GROUND)
a.

Disconnect the Q13 lane departure warning camera connector.


b.
E255432
0.375,0.802 0.781,1.042 0.406,0.24 1.031,1.771 1.292,1.427 true 1.979,1.417 2.365,1.729 true 0.427,0.833 0.802,1.031 0.375,0.198 10 Q13 0.073,0.073 0.385,0.271 0.313,0.198 10 *a 0.74,1.698 1.198,1.896 0.458,0.198 10 IGB 2.438,1.667 2.896,1.865 0.458,0.198 10 GND
*a Front view of harness connector
(to Lane Departure Warning Camera)


Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
Q13-7 (IGB) - Body ground Ignition switch ON 11 to 14 V
Ignition switch off Below 1 V



c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
Q13-11 (GND) - Body ground Always Below 1 Ω


Result:
Proceed to
OK
NG




OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR