Home › Vehicle Interior › LIGHTING (INT) › LIGHTING SYSTEM
RM30B0U _58 Vehicle Interior _010070 LIGHTING (INT) _0054852 LIGHTING SYSTEM U

LIGHTING (INT)  LIGHTING SYSTEM  DATA LIST / ACTIVE TEST  


DATA LIST


NOTICE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


HINT:

Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


a.

Connect the Techstream to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the Techstream on.


d.

Enter the following menus: Body Electrical / Main Body / Data List / All Data.


e.

According to the display on the Techstream, read the Data List.

Body Electrical > Main Body > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
ACC SW Ignition switch ACC signal ON or OFF ON: Ignition switch ACC
OFF: Ignition switch off
"ON" is also displayed for this item when the ignition switch is ON.
IG SW Ignition switch ON signal ON or OFF ON: Ignition switch ON
OFF: Ignition switch off
"OFF" is also displayed for this item when the ignition switch is ACC.
RR Door Courtesy SW Rear door courtesy light switch RH signal ON or OFF ON: Rear door RH open
OFF: Rear door RH closed
-
RL Door Courtesy SW Rear door courtesy light switch LH signal ON or OFF ON: Rear door LH open
OFF: Rear door LH closed
-
Back Door Courtesy SW Back door courtesy light switch signal ON or OFF ON: Back door open
OFF: Back door closed
-
FR Door Lock Pos Front door unlock detection switch RH signal UNLOCK or LOCK UNLOCK: Front door RH unlocked
LOCK: Front door RH locked
-
FR Door Courtesy SW Front door courtesy light switch RH signal ON or OFF ON: Front door RH open
OFF: Front door RH closed
-
FL Door Lock Pos Front door unlock detection switch LH signal UNLOCK or LOCK UNLOCK: Front door LH unlocked
LOCK: Front door LH locked
-
FL Door Courtesy SW Front door courtesy light switch LH signal ON or OFF ON: Front door LH open
OFF: Front door LH closed
-
RR-Door Lock Pos SW LH and RH side rear door unlock detection switch signal ON or OFF ON: LH or RH side rear door unlocked
OFF: LH and RH side rear door locked
w/ Smart Key System
RL-Door Lock Pos SW LH and RH side rear door unlock detection switch signal ON or OFF ON: LH or RH side rear door unlocked
OFF: LH and RH side rear door locked
w/ Smart Key System
Interior Light Control Function which controls interior lights ON or OFF Customized setting displayed -
I/L ON W/Door Key Unlock Function which turns on interior lights when door is unlocked ON or OFF Customized setting displayed -
Lighting Time Lighting time after closing all doors 7.5 s, 15 s or 30 s Customized setting displayed -
Room Light when Aprchd Function which turns on room lights when key is brought within vehicle exterior detection area ON or OFF Customized setting displayed w/ Smart Key System
I/L when ACC OFF Function which turns on lights when ignition switch is turned from ON or ACC to off ON or OFF Customized setting displayed -


ACTIVE TEST


HINT:

Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


a.

Connect the Techstream to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the Techstream on.


d.

Enter the following menus: Body Electrical / (desired system) / Active Test.


e.

According to the display on the Techstream, perform the Active Test.

Body Electrical > Main Body > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Illuminated Entry System Map light, ignition key cylinder light (w/o Smart Key System) and No. 1 room light ON or OFF Turn the map light switch and No. 1 room light switch to the DOOR position.
Relay for Interior Light Auto Cut Function DOME CUT relay ON or OFF -
Body Electrical > Smart Key > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Power/Engine SW Light Engine switch Illumination ON or OFF w/ Smart Key System