DATA LIST
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Body Electrical / (desired system) / Data List / All Data.
According to the display on the Techstream, read the Data List.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| IG SW | Ignition switch ON signal | ON or OFF | ON: Ignition switch ON
OFF: Ignition switch off |
"OFF" is also displayed for this item when the ignition switch is ACC. |
| Parking Brake SW | Parking brake switch signal | ON or OFF | ON: Parking brake switch on
OFF: Parking brake switch off |
- |
| Dimmer SW | Headlight dimmer switch high position signal | ON or OFF | ON: Headlight dimmer switch in high or high flash position
OFF: Headlight dimmer switch in low position |
- |
| Passing Light SW | Headlight dimmer switch high flash position (pass) signal | ON or OFF | ON: Headlight dimmer switch in high flash position
OFF: Headlight dimmer switch not in high flash position |
- |
| Front Fog Light SW | Front fog light switch signal | ON or OFF | ON: Front fog light switch on
OFF: Front fog light switch off |
- |
| Auto Light SW | Headlight dimmer switch AUTO (w/ Automatic Light Control System) or DRL (w/o Automatic Light Control System and w/ DRL OFF Switch) position signal | ON or OFF | ON: Headlight dimmer switch in AUTO position
OFF: Headlight dimmer switch not in AUTO position |
w/ Automatic Light Control System or w/o Automatic Light Control System and w/ DRL OFF Switch |
| Head Light SW (Head) | Headlight dimmer switch head position signal | ON or OFF | ON: Headlight dimmer switch in head position
OFF: Headlight dimmer switch not in head position |
- |
| Head Light SW (Tail) | Headlight dimmer switch tail position signal | ON or OFF | ON: Headlight dimmer switch in tail or head position
OFF: Headlight dimmer switch in neither tail nor head position |
- |
| Illumination Rate Info | Illumination rate information | 0 ms. to 2162.65 ms. | Value output according to ambient light levels | w/ Automatic Light Control System |
| Sensitivity | Sensitivity setting of automatic light control system | Normal, Dark2, Dark1, Light1 or Light2 | Customized setting displayed | w/ Automatic Light Control System |
| DRL Function | Daytime running light function | ON or OFF | Customized setting displayed | w/ DRL OFF Switch |
| Disp Ex ON Sen | Ambient brightness level required to dim light such as indicator lights of combination meter, A/C indicator light and clock | Normal, Dark2, Dark1, Light1 or Light2 | Customized setting displayed | w/ Automatic Light Control System |
| Disp Ex OFF Sen | Ambient brightness level required to cancel dimming of lights such as ndicator lights of combination meter, A/C indicator light and clock | Normal, Dark2, Dark1, Light1 or Light2 | Customized setting displayed | w/ Automatic Light Control System |
| Light Auto OFF Delay | Customized length of time that headlights and taillights are illuminated after closing driver door after ignition switch is turned from ON to off with headlight dimmer switch in AUTO and headlights and taillights on | OFF, 30 s, 60 s or 90 s | Customized setting displayed | - |
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Turn Signal Switch (Right) | Headlight dimmer switch (turn signal switch) right turn position signal | ON or OFF | ON: Headlight dimmer switch (turn signal switch) in right turn position
OFF: Headlight dimmer switch (turn signal switch) not in right turn position |
- |
| Turn Signal Switch (Left) | Headlight dimmer switch (turn signal switch) left turn position signal | ON or OFF | ON: Headlight dimmer switch (turn signal switch) in left turn position
OFF: Headlight dimmer switch (turn signal switch) not in left turn position |
- |
| Hazard Flasher Switch | Hazard warning signal switch signal | ON or OFF | ON: Hazard warning signal switch on
OFF: Hazard warning signal switch off |
- |
ACTIVE TEST
Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Body Electrical / Main Body / Active Test.
According to the display on the Techstream, perform the Active Test.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Daytime Running Light | Daytime running light | ON or OFF | - |
| Taillight Relay | Taillight relay | ON or OFF | - |
| Headlight Relay | Low beam headlight relay | ON or OFF | - |
| Head Light Hi | Headlight dimmer relay | ON or OFF | - |
| Front Fog Light Relay | Front fog light relay | ON or OFF | ·
The headlight dimmer switch is in the tail position. ·
w/ Front Fog Light |