Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC HIGH BEAM SYSTEM
RM30B0U _59 Vehicle Exterior _010071 LIGHTING (EXT) _0054854 AUTOMATIC HIGH BEAM SYSTEM D

LIGHTING (EXT)  AUTOMATIC HIGH BEAM SYSTEM  CUSTOMIZE PARAMETERS  


CUSTOMIZE AUTOMATIC HIGH BEAM SYSTEM


NOTICE:
·

When the customer requests a change in a function, first make sure that the function can be customized.

·

Record the current settings before customizing.



HINT:

The following items can be customized.


a.

Customizing with the Techstream.

i.

Connect the Techstream to the DLC3.


ii.

Turn the ignition switch to ON.


iii.

Turn the Techstream on.


iv.

Enter the following menus: Utility / Customize / Light Control.


v.

Select the setting by referring to the table below.

Light Control
Tester Display Description Default Setting ECU
Automatic High Beam Automatic high beam system ON 0:OFF,1:ON Main body ECU (Multiplex network body ECU)
50006 8
HINT:

The sensitivity adjustment may be difficult to confirm. Check by driving the customer's vehicle.