Home › Vehicle Interior › MIRROR (INT) › INNER REAR VIEW MIRROR
RM30B0U _58 Vehicle Interior _010077 MIRROR (INT) _0054868 INNER REAR VIEW MIRROR G

MIRROR (INT)  INNER REAR VIEW MIRROR  INSPECTION  


PROCEDURE

Hide 1.INSPECT INNER REAR VIEW MIRROR ASSEMBLY (w/ EC Mirror)

a.

Check operation of the electrochromic inner mirror.

E270673
5.167,1.417 5.75,1.417 false 6.333,1.083 6.667,0.417 false 2.042,0.563 2.292,0.563 true 1.24,0.688 1.656,0.688 1.656,0.688 1.656,0.604 true 5,1.333 5.313,1.49 0.313,0.156 10 *1 6.635,0.271 6.948,0.427 0.313,0.156 10 *2 0.354,1.521 0.667,1.677 0.313,0.156 10 *3 1.031,0.125 1.344,0.281 0.313,0.156 10 *a 2.948,2.208 3.26,2.365 0.313,0.156 10 *b 4.844,2.208 5.156,2.365 0.313,0.156 10 *c 1.073,0.615 1.385,0.813 0.313,0.198 10 IG 2.344,0.49 2.656,0.688 0.313,0.198 10 E
*1 Black Colored Tape *2 Forward Sensor
*3 Battery - -
*a Component without harness connected
(Inner Rear View Mirror Assembly)
*b Bright
*c Dark - -


i.

Connect the battery positive (+) lead to terminal 4 (IG) and the negative (-) lead to terminal 1 (E).


ii.

Press the AUTO switch.


iii.

Attach black colored tape to the forward sensor to prevent it from sensing light.


iv.

Shine an electric light on the mirror. Check that the mirror surface changes from bright to dark.

HINT:

When the environment is very bright, the antiglare operation may occur immediately after the tape is applied.


If the result is not as specified, replace the inner rear view mirror assembly.