Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW REGULATOR MOTOR(for Rear Door)
RM30B0U _59 Vehicle Exterior _010076 WINDOW / GLASS _0054873 POWER WINDOW REGULATOR MOTOR(for Rear Door) A

WINDOW / GLASS  POWER WINDOW REGULATOR MOTOR(for Rear Door)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.


Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.


Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION

Hide 3.REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR UPPER ARMREST BASE PANEL LH

Hide 4.REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG LH

Hide 5.REMOVE DOOR ASSIST GRIP COVER LH

Hide 6.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

Hide 7.REMOVE REAR DOOR SERVICE HOLE COVER LH

Hide 8.REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH

Hide 9.REMOVE REAR DOOR QUARTER WINDOW GLASS LH

Hide 10.REMOVE REAR DOOR GLASS SUB-ASSEMBLY LH

Hide 11.REMOVE REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY LH

Hide 12.REMOVE POWER WINDOW REGULATOR MOTOR ASSEMBLY LH

a.
E268556

Using a T25 "TORX" driver, remove the 3 screws and power window regulator motor assembly LH.

NOTICE:

Be careful when removing the screws as the motor may fall and become damaged.