Home › Vehicle Exterior › WINDOW / GLASS › RELAY(for Windshield Deicer)
RM30B0U _59 Vehicle Exterior _010076 WINDOW / GLASS _0054881 RELAY(for Windshield Deicer) G

WINDOW / GLASS  RELAY(for Windshield Deicer)  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.REMOVE FRONT WIPER DEICER RELAY

a.

Remove the deicer relay from the engine room relay block.


Hide 2.INSPECT FRONT WIPER DEICER RELAY

B060778
1.792,0.323 2.052,0.635 true 2.625,0.635 2.906,0.323 true 2.49,1.625 2.958,1.625 true 2.448,1.125 2.917,1.125 true 0.156,1.26 0.302,1.469 0.146,0.208 10 1 1.656,0.094 1.823,0.292 0.167,0.198 10 1 1.208,1.26 1.365,1.448 0.156,0.188 10 2 2.927,0.104 3.104,0.302 0.177,0.198 10 2 1.198,0.719 1.344,0.917 0.146,0.198 10 5 3.0,1.5 3.177,1.688 0.177,0.188 10 3 0.156,0.719 0.302,0.938 0.146,0.219 10 3 3.0,1.0 3.156,1.198 0.156,0.198 10 5

a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 - 5 Battery voltage not applied to terminals 1 and 2 10 kΩ or higher
Battery voltage applied to terminals 1 and 2 Below 1 Ω


If the result is not as specified, replace the deicer relay.


Hide 3.INSTALL FRONT WIPER DEICER RELAY

a.

Install the deicer relay to the engine room relay block.