Home › Vehicle Exterior › WINDOW / GLASS › RELAY(for Window Defogger)
RM30B0U _59 Vehicle Exterior _010076 WINDOW / GLASS _0054882 RELAY(for Window Defogger) G

WINDOW / GLASS  RELAY(for Window Defogger)  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.REMOVE DEFOGGER RELAY

a.

Remove the defogger relay from the main body ECU (instrument panel junction block).


Hide 2.INSPECT DEFOGGER RELAY

B060778
1.792,0.323 2.052,0.635 true 2.625,0.635 2.906,0.323 true 2.49,1.625 2.958,1.625 true 2.448,1.125 2.917,1.125 true 0.156,1.26 0.302,1.469 0.146,0.208 10 1 1.656,0.094 1.823,0.292 0.167,0.198 10 1 1.208,1.26 1.365,1.448 0.156,0.188 10 2 2.927,0.104 3.104,0.302 0.177,0.198 10 2 1.198,0.719 1.344,0.917 0.146,0.198 10 5 3.0,1.5 3.177,1.688 0.177,0.188 10 3 0.156,0.719 0.302,0.938 0.146,0.219 10 3 3.0,1.0 3.156,1.198 0.156,0.198 10 5

a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 - 5 Battery voltage not applied to terminals 1 and 2 10 kΩ or higher
Battery voltage applied to terminals 1 and 2 Below 1 Ω


If the result is not as specified, replace the deogger relay.


Hide 3.INSTALL DEFOGGER RELAY

a.

Install the defogger relay to the main body ECU (instrument panel junction block).