Make sure that fingers or articles of clothing do not get caught in moving parts when performing this test.
1.INSPECT WINDSHIELD WIPER MOTOR ASSEMBLY
| *a | Component without harness connected (Windshield Wiper Motor Assembly) |
Check the LO operation.
Apply battery voltage to the windshield wiper motor connector and check the speed of the windshield wiper motor assembly.
| Measurement Condition | Specified Condition |
|---|---|
| Battery positive (+) → Terminal 5 (+1)
Battery negative (-) → Terminal 4 (E) |
Motor operates at low speed |
Check the HI operation.
Apply battery voltage to the windshield wiper motor connector and check the speed of the windshield wiper motor assembly.
| Measurement Condition | Specified Condition |
|---|---|
| Battery positive (+) → Terminal 3 (+2)
Battery negative (-) → Terminal 4 (E) |
Motor operates at high speed |
If the result is not as specified, replace the windshield wiper motor assembly.