Home › Vehicle Exterior › WIPER / WASHER › FRONT WIPER MOTOR
RM30B0U _59 Vehicle Exterior _010075 WIPER / WASHER _0054883 FRONT WIPER MOTOR G

WIPER / WASHER  FRONT WIPER MOTOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT WINDSHIELD WIPER MOTOR ASSEMBLY

a.
E268321
0.333,2 0.656,2 0.656,2 0.656,1.906 true 0.969,4.521 0.719,4.521 0.719,4.521 0.719,4.229 true 0.354,4.052 0.323,4.375 true 0.052,0.042 0.365,0.24 0.313,0.198 10 false *A 0.052,2.26 0.365,2.458 0.313,0.198 10 false *B 0.865,2.094 1.021,2.292 0.156,0.198 10 false a 0.167,4.177 0.323,4.375 0.156,0.198 10 false b 0.167,1.917 0.479,2.115 0.313,0.198 10 false *1 1,4.448 1.313,4.646 0.313,0.198 10 false *1 0.281,4.396 0.594,4.594 0.313,0.198 10 false *2
*A for LH Side
*B for RH Side
*1 Louver Lip Edge
*2 Fender to cowl seal Lip Edge


Operate the windshield wiper motor assembly.


b.

Stop the windshield wiper motor assembly operation.


c.

Check the automatic stop (park) position.

OK:

The front wiper blade stops at the position shown in the illustration.


Standard:
Area Standard Condition
a 28.4 mm (1.11 in.)
b 25 mm (0.98 in.)


HINT:

After the front wiper blade is stopped, check the automatic stop position after lifting the front wiper blade 2 times.