Home › Vehicle Exterior › WIPER / WASHER › WASHER NOZZLE(for Rear Side)
RM30B0U _59 Vehicle Exterior _010075 WIPER / WASHER _0054890 WASHER NOZZLE(for Rear Side) G

WIPER / WASHER  WASHER NOZZLE(for Rear Side)  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT REAR WASHER NOZZLE SUB-ASSEMBLY

a.

With the ignition switch turned to ON, check that the center stream of washer fluid sprays on the back door glass within the hatched area shown in the illustration.

OK:

Washer fluid hits the back door glass in the area shown in the illustration.


If the result is not as specified, adjust the rear washer nozzle sub-assembly.

E268407
5.521,4.01 5.938,4.01 false 4.917,0.667 4.917,0.417 false 4.583,1.5 5,1.5 false 5.448,3.427 5.448,3.177 false 4.865,0.24 5.177,0.396 0.313,0.156 10 false *1 5.052,1.427 5.365,1.583 0.313,0.156 10 false *2 5.396,3.458 5.708,3.615 0.313,0.156 10 false *1 5.979,3.938 6.292,4.094 0.313,0.156 10 false *2 3.885,3 4.042,3.198 0.156,0.198 10 false A 2.396,3.75 2.552,3.948 0.156,0.198 10 false B 3.552,5.021 3.708,5.219 0.156,0.198 10 false C 4.813,4.031 4.969,4.229 0.156,0.198 10 false D
*1 Glass Edge *2 Wiper Pattern


Standard:
Area Specified Condition Area Specified Condition
A 37.5 mm (1.4764 in.) B 81.5 mm (3.2087 in.)
C 138.6 mm (5.4567 in.) D 139.9 mm (5.5079 in.)