Home › Vehicle Exterior › WIPER / WASHER › WASHER LEVEL WARNING SWITCH
RM30B0U _59 Vehicle Exterior _010075 WIPER / WASHER _0054891 WASHER LEVEL WARNING SWITCH G

WIPER / WASHER  WASHER LEVEL WARNING SWITCH  INSPECTION  


PROCEDURE

Hide 1.INSPECT LEVEL WARNING SWITCH ASSEMBLY

E268388
0.76,2.063 1.073,2.219 0.313,0.156 10 false *a
*a Component without harness connected
(Level Warning Switch Assembly)


HINT:

The following check should be performed with the level warning switch assembly installed to the windshield washer jar assembly.


a.

Fill the windshield washer jar assembly with washer fluid.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 Fluid volume is more than 800 ml 10 kΩ or higher
Fluid volume is less than 600 ml Below 1 Ω


If the result is not as specified, replace the level warning switch assembly.