1.REMOVE QUICK HEATER ASSEMBLY
2.REMOVE NO. 2 HEATER CONTROL CABLE SUB-ASSEMBLY (for Manual Air Conditioning System)
Using a screwdriver with the tip wrapped with protective tape, detach the 3 claws and remove the No. 2 heater control cable sub-assembly.
3.REMOVE AND INSTALL AIRMIX DAMPER CONTROL CABLE SUB-ASSEMBLY (for Manual Air Conditioning System)
Using a screwdriver with the tip wrapped with protective tape, detach the 3 claws and remove the air mix damper control cable sub-assembly.
4.REMOVE NO. 1 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY (for Automatic Air Conditioning System)
Remove the 3 screws and No. 1 air conditioning radiator damper servo sub-assembly.
5.REMOVE NO. 2 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY (for Automatic Air Conditioning System)
Remove the 3 screws and No. 2 air conditioning radiator damper servo sub-assembly.
6.REMOVE NO. 3 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY (for Automatic Air Conditioning System)
Remove the 3 screws and No. 3 air conditioning radiator damper servo sub-assembly.
7.REMOVE HEATER RADIATOR UNIT SUB-ASSEMBLY
Remove the screw and clamp.
Remove the heater radiator unit sub-assembly from the air conditioning radiator assembly as shown in the illustration.
8.REMOVE COOLER EXPANSION VALVE
Using a 4 mm hexagon wrench, remove the 2 hexagon bolts and cooler expansion valve.
9.REMOVE NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY
Remove the 4 screws.
Detach the 2 claws and 2 guides, and remove the lower heater case.
Detach the clamp.
Remove the No. 1 cooler evaporator sub-assembly with the No. 1 cooler thermistor from the upper heater case.
Remove the 2 O-rings from the No. 1 cooler evaporator sub-assembly.
10.REMOVE NO. 1 COOLER THERMISTOR