1.RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
2.REMOVE V-RIBBED BELT
3.DISCONNECT DISCHARGE HOSE SUB-ASSEMBLY
Remove the bolt and disconnect the discharge hose sub-assembly from the compressor assembly with pulley.
Remove the O-ring from the discharge hose sub-assembly.
Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.
4.DISCONNECT SUCTION HOSE SUB-ASSEMBLY
Remove the bolt and disconnect the suction hose sub-assembly from the compressor assembly with pulley.
Remove the O-ring from the suction hose sub-assembly.
Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.
5.REMOVE COMPRESSOR ASSEMBLY WITH PULLEY
w/ Pulley:
Disconnect the connector.
w/ Pulley:
Remove the bolt and disconnect the wire harness bracket.
w/ Magnet Clutch:
Detach the 2 harness clamps and disconnect the 2 connectors.
Remove the 2 bolts and 2 nuts.
Using an E8 ''TORX'' socket wrench, remove the 2 stud bolts and compressor assembly with pulley.