Home › Vehicle Interior › HEATING / AIR CONDITIONING › SOLAR SENSOR
RM30B0U _58 Vehicle Interior _009988 HEATING / AIR CONDITIONING _0054989 SOLAR SENSOR G

HEATING / AIR CONDITIONING  SOLAR SENSOR  INSPECTION  


PROCEDURE

Hide 1.INSPECT AUTOMATIC LIGHT CONTROL SENSOR (SOLAR SENSOR)

a.
E139361
1.917,1.344 2.427,1.104 true 1.938,1.531 2.51,1.531 true 0.969,1.198 1.479,1.344 true 0.135,0.094 0.448,0.25 0.313,0.156 10 *a 0.635,1.094 1.094,1.292 0.458,0.198 10 TSR 2.594,1.427 3.052,1.625 0.458,0.198 10 CLTE 2.49,0.938 2.948,1.135 0.458,0.198 10 TSL
*a Component without wire harness connected
(Automatic Light Control Sensor (Solar Sensor))


Connect the battery's positive (+) lead to terminal 6 and the negative (-) lead to terminal 3, and then measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
1 (TSL) - 3 (CLTE) Sensor subjected to electric light 4.0 to 4.6 V
1 (TSL) - 3 (CLTE) Sensor covered with a cloth 0.8 V or less
2 (TSR) - 3 (CLTE) Sensor subjected to electric light 4.0 to 4.6 V
2 (TSR) - 3 (CLTE) Sensor covered with a cloth 0.8 V or less


NOTICE:

The connection procedure for using a digital tester such as a TOYOTA electrical tester is shown above.


HINT:
·

As the inspection light is moved away from the sensor, the voltage increases.

·

Use an incandescent light for inspection. Bring it within 30 cm (11.8 in.) of the automatic light control sensor (solar sensor).



If the result is not as specified, replace the automatic light control sensor (solar sensor).