1.INSPECT COMBINATION SWITCH ASSEMBLY (ECO SWITCH)
| *a | Component without harness connected
(Combination Switch Assembly (ECO Switch)) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G60-3 (LCC) - G60-4 (EEF) | ECO MODE switch is pushed | Below 1 Ω |
| G60-3 (LCC) - G60-4 (EEF) | ECO MODE switch is not pushed | 1 MΩ or higher |
If the result is not as specified, replace the combination switch assembly (ECO switch).