Wear protective gloves. Sharp areas on the seat frame and adjuster may injure your hands.
If the cushion airbag was deployed, replace the front seat airbag sub-assembly RH, separate type front seat cushion spring assembly, separate type front seat cushion cover and separate type front seat cushion pad with the necessary parts in accordance with the extent of the collision damage.
1. PRECAUTION
Be sure to read Precaution thoroughly before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
3.REMOVE FRONT SEAT ASSEMBLY RH
4.REMOVE RECLINING ADJUSTER RELEASE HANDLE RH
5.REMOVE FRONT SEAT CUSHION SHIELD RH
6.REMOVE FRONT INNER SEAT CUSHION SHIELD RH
7.REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY
8.REMOVE SEPARATE TYPE SEAT CUSHION COVER WITH PAD
9.REMOVE FRONT SEAT AIRBAG SUB-ASSEMBLY RH
Detach the 3 clamps from the separate type front seat cushion spring assembly.
The nuts must not be reused.
Make sure that the separate type front seat cushion spring assembly is not deformed. If it is, replace it with a new one.
Remove the 3 nuts and front seat airbag sub-assembly RH.