Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC LIGHT CONTROL SENSOR
RM30B0U _59 Vehicle Exterior _010071 LIGHTING (EXT) _0055115 AUTOMATIC LIGHT CONTROL SENSOR G

LIGHTING (EXT)  AUTOMATIC LIGHT CONTROL SENSOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT AUTOMATIC LIGHT CONTROL SENSOR

a.
E139361
1.938,1.531 2.552,1.302 true 0.823,1.552 1.479,1.75 true 1.938,1.75 2.479,1.865 true 0.083,0.073 0.396,0.229 0.313,0.156 10 *a 0.448,1.458 0.875,1.656 0.427,0.198 10 CLTB 2.594,1.208 3.021,1.406 0.427,0.198 10 CLTE 2.51,1.802 2.938,2 0.427,0.198 10 CLTS
*a Component with harness connected
(Automatic Light Control Sensor)


Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
6 (CLTB) - 3 (CLTE) Ignition switch on (IG) 11 to 14 V



b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
3 (CLTE) - Body ground Always Below 1 Ω



c.

Reconnect the automatic light control sensor connector.


d.
E162197
1.823,1.323 1.979,1.521 0.156,0.198 10 A 2.927,0.958 3.323,1.135 0.396,0.177 10 GND

Check the waveform of the automatic light control sensor connector.

Waveform:
Tester Connection Tool Setting Switch Condition Specified Condition
3 (CLTE) - 5 (CLTS) 5 V/DIV., 5 msec./DIV. Ignition switch on (IG), headlight dimmer switch on AUTO Correct waveform is as shown


HINT:

If the ambient light becomes brighter, width A becomes narrower.


If the result is not as specified, there may be a malfunction in the automatic light control sensor.