1.INSPECT MAP LIGHT ASSEMBLY (SLIDING ROOF SWITCH ASSEMBLY)
Remove the map light assembly (sliding roof switch assembly).
Click hereVehicle Interior>LIGHTING (INT)>PERSONAL LIGHT>REMOVAL
| *a | Component without harness connected
(Map Light Assembly (Sliding Roof Switch Assembly)) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 1 (GND3) - 5 (UP) | UP switch is pressed | Below 1 Ω |
| 1 (GND3) - 5 (UP) | UP switch is not pressed | 10 kΩ or higher |
| 1 (GND3) - 4 (DOWN) | DOWN switch is pressed | Below 1 Ω |
| 1 (GND3) - 4 (DOWN) | DOWN switch is not pressed | 10 kΩ or higher |
| 1 (GND3) - 3 (OPN) | OPEN switch is pressed | Below 1 Ω |
| 1 (GND3) - 3 (OPN) | OPEN switch is not pressed | 10 kΩ or higher |
| 1 (GND3) - 2 (CLS) | CLOSE switch is pressed | Below 1 Ω |
| 1 (GND3) - 2 (CLS) | CLOSE switch is not pressed | 10 kΩ or higher |
If the result is not as specified, replace the map light assembly (sliding roof switch assembly).
Install the map light assembly (sliding roof switch assembly).
Click hereVehicle Interior>LIGHTING (INT)>PERSONAL LIGHT>INSTALLATION