Home › Engine / Hybrid System › 2AR-FE STARTING › STARTER
RM30B0U _51 Engine / Hybrid System _010840 2AR-FE STARTING _0057906 STARTER A

2AR-FE STARTING  STARTER  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 3.DISCONNECT CABLE FROM POSITIVE BATTERY TERMINAL

Hide 4.REMOVE BATTERY CLAMP SUB-ASSEMBLY

a.
A296163

Remove the bolt and loosen the nut.


b.

Detach the 2 wire harness clamps.


c.

Detach the hook of the battery clamp sub-assembly from the front battery bracket, and then remove the battery clamp sub-assembly.


Hide 5.REMOVE BATTERY INSULATOR

Hide 6.REMOVE BATTERY

Hide 7.REMOVE BATTERY TRAY

Hide 8.REMOVE FRONT BATTERY BRACKET

A296164

a.

Remove the 4 bolts and front battery bracket.


Hide 9.REMOVE BATTERY BRACKET REINFORCEMENT

A296165

a.

Remove the 2 bolts and battery bracket reinforcement.


Hide 10.REMOVE STARTER ASSEMBLY

A296166

a.

Disconnect the starter connector and remove the terminal cap.


b.

Remove the nut and disconnect the starter wire.


c.
A194738

Remove the 2 bolts and starter assembly.