Home › Engine / Hybrid System › 2AR-FE STARTING › STARTER
RM30B0U _51 Engine / Hybrid System _010840 2AR-FE STARTING _0057906 STARTER A

2AR-FE STARTING  STARTER  DISASSEMBLY  


PROCEDURE

Hide 1.REMOVE MOTOR TERMINAL STARTER KIT

a.
A296167

Remove the nut and disconnect the lead wire from terminal C.


b.
A296168

Remove the 2 screws holding the motor terminal starter kit to the repair service starter kit.


c.

Remove the motor terminal starter kit.


d.

Remove the return spring and plunger from the repair service starter kit.


Hide 2.REMOVE STARTER YOKE ASSEMBLY

a.
A296169

Remove the 2 through bolts and pull out the starter yoke assembly together with the starter commutator end frame assembly.


Hide 3.REMOVE STARTER COMMUTATOR END FRAME ASSEMBLY

a.
A251392

Remove the starter commutator end frame assembly from the starter yoke assembly.


Hide 4.REMOVE STARTER ARMATURE PLATE

A284247

a.

Remove the starter armature plate from the starter yoke assembly.


Hide 5.REMOVE STARTER COMMUTATOR END FRAME COVER

a.
A296170

Using a screwdriver, remove the starter commutator end frame cover.


Hide 6.REMOVE STARTER ARMATURE ASSEMBLY

A296171
0.958,0.521 1.198,0.521 1.198,0.521 1.531,0.688 false 0.771,0.448 1.083,0.604 0.313,0.156 10 *1
*1 Snap Ring Pliers


a.

Using snap ring pliers, remove the snap ring and washer.

NOTICE:

Do not drop the starter armature assembly.



b.

Remove the starter armature assembly from the starter commutator end frame assembly.


Hide 7.REMOVE PLANETARY GEAR

a.
A296172

Remove the 3 planetary gears from the repair service starter kit.